Door hanging can be a daunting task for many people, but it’s not as difficult as one might think. To help you get through the process with ease, we’ve compiled a few of our best door hanging tips and suggestions to ensure that your doorway opens and closes quickly. This guide on how to hang a door will instruct you through the entire process from start to finish.
When looking to hang a door, you’ll likely need to know a little bit more about the house’s layout and surroundings before choosing how to rig your hinges.
The first thing you’ll want to do is find the studs located on the wall where your door will be. Studs are the vertical wood planks that support your home. A small stud finder device can help you find these, but you can quickly locate them by hammering a nail into the wall if you don’t have this handy.
Once you’ve located the studs, you’ll want to draw a line straight down from the door’s hinge to where the studs are. This will help you get a better idea of how high to hang your door.
If you’re installing the entire door frame, you’ll want to hang your frame before placing the door in place. This is because door frames are typically much heavier than the door itself, so they will be easier to handle when they’re in their entirety.
Now you’re ready to hang the door
To hang your door, begin by getting it into place. You want to ensure that the hinge of the door is centered over the stud of the opening. Make sure you have your baseboard level to match.
Once you have the door in place, you’ll want to drive a nail through the hinge and into the stud. Then, using a hammer, drive in enough nails through each hinge until they are secure in place.
Once the hinge is secured, you’ll want to attach the door’s frame. While most doors use a standard type of frame, you must be able to measure the width and height of your doorway before placing your wood in place.
Next, you’ll want to secure your frame with another nail through the hinge and into the stud. You’ll also want to place a few small nails into the frame, as you must have a tight fit to ensure that your door will close properly.
Once you’ve secured the doorway, you’ll want to adjust the hinges so that they are both perfectly level. Without this, your door will not be able to close correctly. Fitting a door in such a manner is a must because it will ensure that it opens and closes properly.
The last step is to install the strike in your door
A strike is a tiny clasp that will prevent your door from swinging further than you desire it to. Install it with the exterior facing upwards, and make sure that it is flush with the inside of your doorway.
Once you’ve installed the strike, you’re ready to hang your door. To do this, open your door and place your hinges over the strike. This will ensure that it closes properly.
You’ll want to repeat these steps when hanging your door. It is also highly recommended that you have someone there to assist you when doing so, as you will likely need help lifting the door when placing it in place.